Filter
Top Products
28
4830 & 4832
Attaching a button
Recommended settings:
Stitch Selection: Zig-Zag Stitch
Needle Position:
Stitch Width: To suit Button Sewing (H)
(Additional Accessory)
Needle Plate: General Purpose (A)
Attach Feed Cover (F)
Note: Before you can attach a button, the
bobbin thread must be brought up
through the hole in the feed cover.
1. Set stitch width at ( ) and needle position
selector at ( ). Position button under foot
and lower the needle into the center of the
left kid. Lower the foot. Turn hand wined
toward you until needle rises out of button
and is above the foot.
2. Move stitch width selector until needle is
over the other hole in the button. Then,
when you begin to ditch, the needle should
enter into the right hole of the button. Take
six or more zig-zag stitches to attach but-
ton and finish with the needle on the left
side.
3. To fasten stitching, adjust width to ( ) and
take three or four stitches. Remove work,
draw threads to underside, fasten, and
trim.