Filter
Top Products
- HOW TO INSTALL YOUR HOME DRINKING WATER SYSTEM -
MAKE REMAINING RO CONNECTIONS - continued
B. CONNECT TUBING, FAUCET TO DRAIN TUB-
ING CONNECTOR
Looking at FIG. 7 and page 16, run the 3/8" x 27"
tubing from the RO faucet, to the connector at the
adapter you installed in the sink drain pipe. Cut this
tubing as needed to route in as straight of a run as
possible without dips, loops, low spots or kinks.
Be sure the end of the tubing is cut square, then
push the end into the connector until it stops (about
11/16"). Pull on the tubing to be sure it is held se-
curely.
C. CONNECT TUBING TO WATER SUPPLY
Use the tubing insert, ferrule and nut, at the water
supply saddle valve, to fasten the remaining 1/4"
tubing (marked "WATER SUPPLY"). Tighten the
nut with a wrench.
D. Fasten the faucet base and electronic box lead-
wire connectors together, routing where dry, and
out of the way.
STEP 5 -- SANITIZING, PRESSURE TESTING, PLACING IN "SERVICE"
A. DO THE SANITIZING PROCEDURES, PAGE
15. THEN, CONTINUE WITH STEP B.
B, Double check all tubing connections to be sure
they are tightened.
C. Open the house main water supply valve and
the supply saddle valve (turn handle fully out). Open
the tank shutoff valve...see below.
D. In about 4 hours, pressure will start to build in
continued on next Daae
FAUCET
3/8" tubing,
27" long (cut to
length needed)
,-faucet base
DRAIN ADAPTER--._
2
HOT WATER
SUPPLY SADDLE VALVE
COLD WATER
1/4" tubing
(WATER SUPPLY)
i
(1/4" see steps 6 & 7,
pages 8 & 9, and
3/8" tubir FIG. 6 to
connect
OPEN
TANK
SHUTOFF VALVE
posffilter
CLOSED
ferrule
nut
NOTE: Codes in tile state of Massaei_usetbs raqutre mstah
/at,on Oy a licensed plumt_er, and do not permit the use of
the saddle valve¸ For insla_lation, use plumbing code
248-CMR of the CommonweaJth of Massachusetts¸
box
RO
ASSEMBLY
leadwire connection
batte_
pack
10