Filter
Top Products
SECTION 2. PREPARE THE MACHINE FOR SEWING
Bobbin Wind
f
Horizontal Spool Pin
®@
Additional Spool Pin
®
(_)0 ,,,,A
(_ Pull the clutch knob away trom the machine to disengage clutch.
(_ Draw the thread from the spool,
(_ Guide the thread around the bobbin winder thread guide.
(_ Insert the thread through the hole in the bobbin, threading lrom the inside to the outside.
(_) Put the bobbin on the bobbin winding spindle, and push it to the right.
(_ With the free end ol the thread held in your hand, depress the loot control.
(_ Stop the mach=ne when it has made a few turns, and cut the thread close to the bobbin.
Depress the toot control again. When the bobbin Jstully wound, it wilt stop automatically.
Return the bobbin winder to its original position by moving the spindle to the left, and cut the thread as
shown.
(_ Push in the clutch knob to engage clutch.
_" The machine witl not sew until the clutch knob is pushed in.
f
NOTE:
The bobbin winder stopper can be adjusted for
the amount of thread needed on the bobbin
(example t/2 tuli or tult etc.). To make the
adiustment use your large screw driver and
loosen the screw one turn or less, This will
a!low you to adjust t he position of bobbin
winder stopper. Do not take screw all the
wayout.
17