Filter
Top Products
■ How to start group operation
To start group operation
The flap setting can be performed only for units that have no remote
controllers.
NOTE
OI-432-04 - 8EG
4 - 8
Power Turn the power supply switch on more than 5 hours before starting operation.
1 Press the SELECT button and select GROUP.
2 Select the ZONE No. including the group to be operated by pressing ZONE button.
3 Select the GROUP No. to be operated by pressing GROUP select buttons .
4 Press the ON button.
5 Set the operation mode by pressing the MODE button.
6 Set the desired temperature by pressing one of the temperature setting buttons .
7 Set the desired fan speed by pressing the FAN SPEED button.
8 Set the airflow direction to a specific angle or sweep mode.
9 By pressing , select your desired setting.
Individual: → Controls with the remote controller are possible.
Central 1: → Individual ON/OFF operation with the remote controller is inhibited.
Central 2: → Individual ON/OFF, MODE, and Temp. setting operations with the remote
controller are inhibited.
Central 3: → Individual MODE and Temp. setting operations with the remote controller are
inhibited.
Central 4: → Individual MODE operation with the remote controller is inhibited.
• Under Central/Individual settings other than listed above, “CENTRAL” is displayed.
AUTO Depending on the difference between the temperature setting and the room temperature,
Operation heating and cooling alternate automatically so that a uniform room temperature is maintained.
Stop Confirming the GROUP No. to be selected, press the OFF button.
8
9
1
2
5
6
7
3
Stop
4
4
4 SHA-KC64UG 5/2/01 2:30 PM Page 8