Sanyo TM-SH80UG Air Conditioner User Manual


 
Using the Wireless Remote
Controller
1. Press and slide the lid on the back of the wireless remote controller in the
direction of the arrow.
2. Install two AAA alkaline batteries (LR03). Make sure the batteries point in
the direction marked in the battery compartment.
3. Press the ACL button, then replace the lid. If you press it, the current
time, ON time, and OFF time are all reset to 0:00.
The batteries last about six months, depending on how much you
use the wireless remote controller.
Replace the batteries when the wireless remote controller’s lamp
fails to light, or when the wireless remote controller cannot be
used to change the air conditioner’s setting.
Use two fresh leak-proof type-AAA alkaline batteries (LR03).
In replacing batteries, follow the instructions as mentioned in the
sub-section ‘‘How to Install Batteries’’.
If you do not use the wireless remote controller more than 1
month, take out the batteries.
OI-404-02 - 7EG
2 - 7
ACL button
How to Install Batteries
2
2 RCS-SH80UA.WL 5/2/01 2:18 PM Page 7