Filter
Top Products
21
Adjusting the Airflow Direction
The horizontal and vertical airflow
can be adjusted by moving the
vertical vanes and the flap with the
remote control unit. Confirm that
the remote control unit has been
turned on. Use the FLAP button to
set either the sweep function or
one of the six airflow direction
settings.
When the humidity is high, the vertical vanes should be in the front
position during the cooling or dehumidifying operation. If the vertical
vanes are positioned all of the way to the right or left, condensation
may begin to form around the air vent and drip down.
1.Horizontal
A. Sweep function
The vertical vanes move left and right to deliver air over the sweep
range.
B. Setting the airflow manually
Referring to above illustration, use the FLAP button to set the
airflow direction within the range used during the heating, cooling
or dehumidifying operation.
C. Auto flap function
The flap is set to the recommended position.
2.Vertical A. Sweep function
The flap starts moving up and down
to deliver air over the sweep range.
B. Setting the airflow manually
Referring to the above illustration,
use the FLAP button to set the airflow
direction within the range used during
the heating, cooling, or dehumidifying
operation.
C. Auto flap function
The flap is set to the
recommended position.
• The flap automatically closes when the unit is off.
• During the heating operation, the fan speed will be very low and the flap
will be in the horizontal position (position ) until the air being blown out
of the unit begins to warm. Once the air warms up, the flap position and
fan speed change to the settings specified with the remote control.
• Use the FLAP button on the remote control to adjust the position of
the flap. If you move the flap by hand, the flap position according to
the remote control and the actual flap position may no longer match. If
this should happen, shut off the unit, wait for the flap to close, and
then turn on the unit again; the flap position will now be normal again.
• Do not have the flap pointed down during cooling operation.
Condensation may begin to form around the air vent and drip down.
CAUTION
SweepWideAuto
COOL
DRY
FAN
HEAT
SWEEP
SWEEP
NOTE
CAUTION
OI-791-21-EG
01_SAP-KRV94EHDX_EN.fm Page 21 Monday, August 15, 2005 7:05 PM