Filter
Top Products
10
Remote Control Unit (continued)
Using the Remote Control Unit
SENSOR button When you press this button (use a small-tipped object such as a ballpoint
pen), the mark will appear at the display. And the room temperature is
detected by the sensor which is built into the indoor unit and the air
conditioner is controlled accordingly.
If the remote control is located near a heat source, such as a space heater or
in direct sunlight, press the SENSOR button to switch to the sensor on the
indoor unit.
Temperature Display Selector
button
This switches the temperature display between °C and °F.
Time Display Selector button This switches the time display between 24-hour time and 12-hour time.
TIMER Selector button
(ONE TIME/EVERYDAY)
This button switches ONE TIME or EVERYDAY. When you select
EVERYDAY, is displayed and continuously operates this function
everyday. The initial setting is EVERYDAY. If you select ONE TIME, it
operates until setting time of timer.
CANCEL button If you want to cancel the setting time of ON or OFF, press the ON or OFF button
first, then press the CANCEL button. The CANCEL function is invalid for the
1.2.3.5HR. TIMER.
CLOCK button The CLOCK button is used to set the present time. Press the CLOCK button
first, then select the advance or return keys on the ON or OFF TIME setting
button. Press the CLOCK button again to set adjusted present time.
CHILD LOCK button The CHILD LOCK button is used to tamperproof and protect the unit from
being incorrectly operated. The setting or canceling this function is effected
by pressing the button for at least two seconds.The initial setting is set to
CHILD LOCK off.
: CHILD LOCK on.
All key access functions are invalid while the CHILD LOCK function is on.
ADDRESS switch • The ADDRESS switch changes to prevent mixing of signals from remote
control units when two air conditioners are installed next to each other.
The ADDRESS switch is located inside of rear cover on the remote
control unit, and is set to A. For more information, please contact the
dealer where you made the purchase.
• Normally, tab on the remote control unit should not be bent.
The remote control unit sends the temperature signal to the air conditioner regularly at five minute
intervals. If the signal from the remote control unit stops for more than 15 minutes due to the loss of
the remote control unit or other trouble, the air conditioner will switch to the temperature sensor which
is built into the indoor unit and control the room temperature. In these cases, the temperature around
the remote control unit may differ from the temperature detected at the air conditioner’s position.
How to Install Batteries
NOTE
NOTE
NOTE
1.
S
lide the cover in the direction
indicated by the arrow and remove it.
2. Install two AAA alkaline batteries.
Make sure the batteries point in the
direction marked in the battery
compartment.
OI-791-10-EG
01_SAP-KRV94EHDX_EN.fm Page 10 Monday, August 15, 2005 7:05 PM