Filter
Top Products
9
Remote Control Unit (continued)
<Cover opened>
ON TIME/OFF TIME setting
buttons
No display: The timer does not operate.
: The air conditioner starts at the set time.
: The air conditioner stops at the set time.
: The air conditioner stops and starts, or starts and stops, at
the set times every day. For details, see “Setting the Timer”.
MODE selector button Use this button to select AUTO, HEAT, DRY, COOL or FAN mode.
(AUTO) : When this setting is selected, the air conditioner calculates the
difference between the thermostat setting and the room temperature
and automatically switches to the ‘‘COOL’’ or ‘‘HEAT’’ mode as
appropriate.
(HEAT) : The air conditioner makes the room warmer.
(DRY) : The air conditioner reduces the humidity in the room.
(COOL) : The air conditioner makes the room cooler.
(FAN) : The air conditioner works only as a circulation fan.
FAN SPEED selector button : The air conditioner automatically decides the fan speeds.
: High fan speed
: Medium fan speed
: Low fan speed
NIGHT SETBACK button For details, see “5. Night Setback Mode”. When you press this button in the
HEAT, DRY or COOL mode, the mark appears in the display, and the
remote control unit will automatically adjust the set temperature to save
energy.
FLAP button
(up/down)
Press the button either to select the setting of the airflow direction to
auto. flap in each mode or to one of the six possible positions from (2) to (7)
or to select the sweep function which moves the flap up and down
automatically.
: Auto flap setting: If selected in a heating operation, the flap is set to
position (3) in the following chart. If selected in a cooling or dry
operation, the flap is set at position (7) in the following chart.
: The airflow direction can be set at six positions from (2) to (7).
: The flap moves up and down automatically.
When you press the button, the air flow direction will change one by one
as follows.
FLAP button
(left/right)
Press the button either to select the setting of the airflow direction to
auto. flap in each mode or to one of the six possible positions from (2) to (7),
or to select the sweep function which moves the flap left and right
automatically.
: Auto flap setting: The flap is set at position (4) in the following chart.
: The airflow direction can be set at six positions from (2) to (7).
: The flap moves left and right automatically.
When you press the button, the airflow direction will change one by one
as follows.
NOTE
SWEEP
NOTE
WIDE SWEEP
OI-791-9-EG
01_SAP-KRV94EHDX_EN.fm Page 9 Monday, August 15, 2005 7:05 PM