Filter
Top Products
3Setting up the device
English
• HumidAire™ heated humidifier
• ResMed Passover humidifier.
!
WARNING
The HumidAire 2i, HumidAire 2iC, HumidAire heated humidifier and the ResMed
Passover are compatible for use with this device. Please refer to Warnings on
page 18.
Setting up the device
Place the device on a flat surface near the head of your bed.
!
CAUTION
• Be careful not to place the device where it can be bumped or where
someone is likely to trip over the power cord.
• Make sure the area around the flow generator is dry and clean. It should also
be clear of bedding, clothes and other potential blockages.
1 Connect the power cord.
Note: ResMed recommends using the AC power cord supplied with the unit. If a
replacement power cord is required, contact your ResMed service centre.
2 Plug the free end of the power cord into a power outlet.
!
CAUTION
Do not connect both AC and DC power cords to the device at the same time,
unless otherwise specified.
!
WARNING
• Make sure the power cord and plug are in good condition and the
equipment is not damaged.
• The air filter cover protects the device in the event of accidental liquid
spillage onto the device. Ensure that the air filter and air filter cover are fitted
at all times.
3 Connect one end of the air tubing firmly onto the air outlet of the device.
Power switch
AC locking clip
AC power cord