Filter
Top Products
4
!
WARNING
Only ResMed air tubing should be used with your flow generator. A different
type of air tubing may alter the pressure you actually receive and reduce the
effectiveness of your treatment. Do not use conductive or anti-static hoses or
tubes.
4 Connect your mask system to the free end of the air tubing.
Attaching a Humidifier
!
WARNING
When using a humidifier, position it lower than your sleeping position, so that
any excess condensation drains back into the water chamber, and at the same
level or lower than the device.
Notes:
• You must activate the humidifier option in the menus if you are using a HumidAire or
Passover humidifier.
• For details on using humidifiers, please see you relevant user manual.
HumidAire 2i/2iC Humidifier
The HumidAire 2i or 2iC attaches to the front of the device to provide heated or passover
humidification, respsectively. No other accessories are required for its use. The
VPAP III ST-A with QuickNav automatically detects the presence of the HumidAire 2i.
HumidAire or Passover Humidifier
Medium size (52 cm) air tubing is a necessary accessory for connecting the device to the
HumidAire or Passover humidifier.
Note: Place the device on top of the humidifier. Do not place the device underneath the
humidifier. (This is to avoid water spilling into the device.)
Using the LCD QuickNav Screen and Keypad
The control panel of this device includes an LCD screen, LEDs and keypad.
LCD Screen
The LCD screen displays the menus, treatment screens and alarm conditions.
Alarm LEDs
Alarm Mute
Start/Stop
Exit key
Enter (Soft) key
Up/Down key
LCD QuickNav screen
(green)
QuickView
(red)
Therapy LED