Filter
Top Products
Regency
®
F33-3 Freestanding Gas Stove 5
INSTALLATION
10) Installation and any repairs to this appliance should be done by an
authorised service person. An authorised service person should
be called to inspect this appliance annually. Make it a practice to
have all of your gas appliances checked annually.
11) Do not strike the glass door.
12) Under no circumstances should any solid fuels (wood, paper,
cardboard, coal, etc.) be used in this appliance.
13) The appliance area must be kept clear and free of combustible
materials, (gases and other fl ammable vapours and liquids).
IMPORTANT
SAVE THESE INSTRUCTIONS
The F33-3 Freestanding Gas Stove must be installed in accordance
with these instructions. Carefully read all the instructions in this manual
fi rst. Consult the "authority having jurisdiction" to determine the need
for a permit prior to starting the installation.
INSTALLATION CHECKLIST
1) Locate your appliance. Refer to the "Clearance to Combustibles"
section.
2) Assemble stove base. Refer to the "Pedestal Assembly" or "Leg
and Bottom Shield Assembly" sections.
3) Install fl ueing. Refer to the "Flueing" section.
4) Make gas and electrical connections. Refer to the "Gas Connec-
tion" section.
Test the pilot. Must be as per diagram in the "Pilot Adjustment"
section.
5) Test gas pressure. Refer to the "Gas Pipe Pressure Testing"
section.
6) Test for fl ue spillage. Refer to the "Test for Flue Spillage"
section.
7) Install logs and embers and rockwool where indicated in the "Log
and Ember Installation" section
8) Install optional features. Refer to the following sections where
applicable.
a. Optional Remote Wall Switch
b. Optional Remote Control Installation
c. Optioanl Wall Thermostat Installation
9) Final check. Refer to the "Final Check" section.
Before leaving this unit with the customer, the installer must ensure
that the appliance is fi ring correctly and operation fully explained to
customer.
This includes:
1) Clocking the appliance to ensure the correct fi ring rate (rate noted
on label) after burning appliance for 15 minutes.
BEFORE YOU START
INSTALLATION AND REPAIR SHOULD BE DONE BY AN AU-
THORISED SERVICE PERSON. THE APPLIANCE SHOULD
BE INSPECTED BEFORE USE AND AT LEAST ANNUALLY
BY AN AUTHORISED SERVICE PERSON. MORE FREQUENT
CLEANING MAY BE REQUIRED DUE TO EXCESSIVE LINT
FROM CARPETING, BEDDING MATERIAL, ETC. IT IS IMPERA-
TIVE THAT CONTROL COMPARTMENTS, BURNERS AND
CIRCULATING AIR PASSAGEWAYS OF THE APPLIANCE BE
KEPT CLEAN.
DUE TO HIGH TEMPERATURES, THE APPLIANCE SHOULD BE
LOCATED OUT OF TRAFFIC AND AWAY FROM FURNITURE
AND DRAPERIES.
WARNING: FAILURE TO INSTALL THIS APPLIANCE COR-
RECTLY MAY CAUSE A SERIOUS HOUSE FIRE AND WILL
VOID YOUR WARRANTY.
CHILDREN AND ADULTS SHOULD BE ALERTED TO THE
HAZARDS OF HIGH SURFACE TEMPERATURES, ESPECIALLY
THE FIREPLACE GLASS, AND SHOULD STAY AWAY TO AVOID
BURNS OR CLOTHING IGNITION.
YOUNG CHILDREN SHOULD BE CAREFULLY SUPERVISED
WHEN THEY ARE IN THE SAME ROOM AS THE APPLI-
ANCE.
CLOTHING OR OTHER FLAMMABLE MATERIAL SHOULD NOT
BE PLACED ON OR NEAR THE APPLIANCE.
GENERAL SAFETY
INFORMATION
1) The appliance installation must conform with local codes or, in the
absence of local codes, with AS5601-2004 or NZS 5261
2) The appliance when installed, must be electrically grounded in
accordance with local codes, or in the absence of local codes with
the current National Electrical Code, AS 3100
3) See general construction and assembly instructions.
4) This appliance must be connected to a fl ue and terminate to the
outside of the building envelope. Never fl ue to another room or
inside a building.
5) Inspect the fl ue system annually for blockage and any signs of
deterioration.
6) Any safety glass removed for servicing must be replaced prior to
operating the appliance.
7) To prevent injury, do not allow anyone who is unfamiliar with the
operation to use the fi replace.
8) Wear gloves and safety glasses for protection while doing required
maintenance.
9) Under no circumstances should this appliance be modifi ed. Parts
that have to be removed for servicing should be replaced prior to
operating this appliance.