Filter
Top Products
Greenfi re Pellet Stove and Insert Technical Manual
18
INSTALLATION
INSTALLATION AND REMOVAL OF CONTROL PANEL IN THE SURROUND PANEL
When installing the circuit board control panel into the surround panel,
the surround does not need to be assembled. The circuit board will be
found in the fi rebox.
Place the circuit board control panel on the backside of the right surround
panel so the hinge is on the outside and the top and bottom holes on the
control panel line up with those on the surround. Attach using two (2) T-
20 screws through the front of the surround into the circuit board control
panel (see Figure 30).
After the surround has been assembled and is ready to be installed on the
unit plug the wiring harness into the control panel (see Figure 31).
REMOVAL:
When maintenance is required on the unit the surround must be removed.
Pull the surround straight up till it stops then pull it out about 4” (10 cm)
and rest the surround on top of the unit while the control panel is removed
or disconnected.
If electrical connection is required for the maintenance remove the circuit
board control panel from the surround.
If electrical connection is not required for the maintenance remove the
wiring harness from the bottom of the circuit board control.
Plug
Figure 31: Right Panel
- Back.
Figure 30: Right Panel
- Front.
ASSEMBLY AND INSTALLATION OF INSERT SURROUND PANELS
The trim set for your surround panel must be installed before installing the
surround panel onto the unit, if not already done.
1. To assemble the surround panels, lay the panels face down on a soft
fl at surface and align the outer edges of the sides with the top panel.
Using four (4) T-20 screws up through the side panels into the top (see
Figure 32).
Figure 32: Assembled Surround Panel.
Figure 33: Installed Surround Panel.
2. Place the assembled surround panel around the stove; align the slots
with the screw heads. Push surround in then down to engage the sur-
round slots on the mounting screws (see Figure 33). Make sure the
top surround panel sits fl at behind the stove top.
INSTALLATION