Filter
Top Products
11
FPI U31-2 Gas Fireplace Insert
INSTALLATION
Logs D)02-46 and E)02-47 in position.
6) Place the Left Top Log D)02-46 on the pin
on Log C)02-56 and on top of the cutout on
Log A)02-43.
7) Place the notch in Center Log E)02-47 over
Log B)02-45 and across the cutout on Log
A)02-43.
Cutout
Pin
Cutout
Notch
8) Position notch in Front Right Log F)02-48
on Log E)02-47 and push the bottom right
edge against the bracket on the burner tray
and the front edge of the rear burner.
Notch
Bracket
10) Place the embers and Rockwool on the
exposed front burner tray.
11) Test fi re to ensure proper light off (make
sure fl ame fl ows smoothly from one end
of burner to the other. If there is any fl ame
hesitation, check that area for any blockage
of the burner port.
12) Install fl ush glass and optional bay glass
as per instructions in this manual.
D)02-46
E)02-47
9) Place Front Left Log G)02-44 onto the 2
front pins as shown.
G)02-44
C)02-56
A)02-43
B)02-45
A)02-43
F)02-48
B)02-45
Bracket
A)02-43
Front edge of
rear burner
The bottom right edge of Log F)02-48 must
sit snugly against the bracket and the front
edge of the rear burner.
Side View
Pins on Rear Log Support
Logs A)02-43, C)02-56,
and B)02-45 in position
A)02-43
B)02-45
C)02-56
3) Place Rear Log A)02-43 on the two pins on
the rear log support.
4) Place Front Right Log B)02-45 on the two
pins as shown.
5) Place the Middle Left Log C)02-56 on the
two pins as shown.
F)02-48
B)02-45
E)02-47
C)02-56
A)02-43
B)02-45
F)02-48
D)02-46
G)02-44
E)02-47