Filter
Top Products
Page 22
7033-277C
March 2, 2007
R
3100 Wood Stove Series (ACC)
Installing Pedestal Assembly
1. Remove screws on adapter and slide pedestal over
adapter on bottom of stove. Figure 22.1.
2. Line up holes in sides of pedestal with holes in adapter.
3. Securely tighten pedestal into place.
4. Carefully stand stove up and place in desired location.
5. Slip wooden decorative strips onto pedestal edges.
Finishing the ARS Installation
1. The ARS channel is already installed on the stove. S
et
the grate into the ARS channel and secure with 2
bolts previously removed. Replace the 2 front cut
bricks. Figure 22.2.
2. Install the ash drawer.
3.
Check to make sure baffl e boards and ceramic blanket
are in their proper locations (see page 28).
NOTE: If installing a fl oor installation of an outside air kit on a
Step Top model with a pedestal assembly you must attach
the enclosed cover plate to the back of the stove. Other
wise you may discard this piece. See Figure 22.3.
Pedestal and Ash Removal System (Cont’d)
Figure 22.3
Grate
ARS
Channel
Replace both bricks
back into firebox
Figure 22.2
Cover
Plate
Ash Removel
Drawer
Adapters
Oak
Pedestal
Trim
Figure 22.1