Filter
Top Products
March 2, 2007
7033-277C
Page 21
3100 Wood Stove Series (ACC)
R
7
Appliance Set Up
Figure 21.3
Do NOT operate before fully assembling components.
Burning your stove without a pedestal or leg kit
attached:
• Will void your warranty.
• May result in property damage or personal injury.
WARNING
NOTE: The Ash Removal System, must be
installed fi rst before installing the pedestal.
A. Pedestal Assembly and Ash Removal
System (ARS) Installation for Step Top
Uni-body
Included in Kit: Door assembly, door handle & magnet,
ash grate, ash grate channel, ash drawer, fastener package.
A cover plate that is required for a fl oor outside air instal-
lation on a pedestal model is also included, If not needed,
discard.
Tools Required: Phillips head screw driver, 7/16 socket
wrench, 3/32 and 5/36 Allen wrench.
Begin installing the ARS System.
1. Remove 2 bricks as shown in Figure 21.1
2.
Lay body of stove on its back on a protective pad or pallet.
3. Remove the 2 nuts and 2 bolts holding the grate in place
and set the grate aside. Discard the 2 nuts. I
nstall the
gasket over the 4 protruding screws. Figure 21.2.
4. Install ash door assembly by sliding the rod at an angle
into the slot on the left side and sliding over the 4 screws
protruding from the bottom of the stove. Secure with nuts
provided. Figure 21.2.
5. Install magnet using a Phillips head screw driver. This
magnet will hold the door handle in an open position
which in turn holds the ash door open so ashes can be
brushed into the ash drawer. Figure 21.2.
6. Install door handle by placing over rod and sliding to the
right. While in an open position, line up the set screw with
the fl at side of the rod and tighten the set screw using
a 3/32 Allen wrench. The set screw needs to be snug.
Figure 21.3.
Door handle must be
in open position to
tighten set screw
Set Screw
(align with flat
side of rod)
Ash Door Rod shown
in installed position
2
2
Remove for
installation and
then re-install
Gasket
Slide rod at an
angle into slot
Ash Door
Assembly
Magnet
Lay stove flat on
protective padding or
pallet
Door Handle
Figure 21.1
Figure 21.2