Filter
Top Products
6
Safety
CAUTION! This machine is an electrical appliance. Care must be
taken to reduce the risk of electrical shock.
• READ AND UNDERSTAND ALL INSTRUCTIONS BEFORE OPERATING THE M1200.
• To reduce the risk of property damage or injury, repairs to electrical systems should only be performed by
experienced technicians. Contact your distributor for assistance.
• Unplug machine power cord from outlet before performing any repairs on the extractor.
• Plug unit into grounded outlets only. Do not remove ground prong from plug. Use of a Ground Fault
Interrupting (GFI) device will reduce the risk of electrical shock.
• Do not use the M1200 outdoors, in standing water or on wet surfaces.
• Do not store the M1200 in wet conditions.
• If extractor is leaking, unplug machine power cords from outlets before approaching or touching machine.
• Do not unplug power cord by pulling on the cord. Grasp the plug when unplugging the cord.
• Do not pull the extractor by the cord.
• If cord or plug is damaged, do not use cord. Replace with new cord or repair as needed before use.
• The power cords used must be able to handle an electrical load of 20amps each.
• The two power cords must be plugged into separate circuits during operation. Power Cord #1 must be on a
20amp circuit to use both vacuums. Power Cord #2 can be on a 15amp if the Auto Pump-out is not used or a
20amp circuit if it is used. The use of a Breaker Buddy (Hydro-Force part number AX49) will ensure that the
two cords are operating on different circuits (see page 8 for details.)
Sectio
n
1