Filter
Top Products
27
CLEAN THE HYDRO-FILTER:
Build-up of debris in the filter bag of the Hydro-Filter will reduce the vacuum air flow and may cause a
significant decrease in water recovery. A torn filter bag will allow debris past the filter and into the recovery
tank. This debris can clog the Waste Pump and the Vacuum Shutoff Assembly. The Hydro-Filter must be
examined and cleaned regularly to keep the M1200 functioning properly:
• Push the latch lever and open the Hydro-Filter lid.
• Remove the filter bag. Examine the bag and clean or replace as needed.
• Rinse the body of the Hydro-Filter with clean water.
• Examine the o-ring seal and replace as needed.
• Re-install the new or cleaned bag.
• Close lid and secure latch.
RINSE OUT RECOVERY TANK:
Build-up of fine silt and debris can damage the Waste Pump and Drain Valve. Clean out the tank on a regular
basis to extend the life of these components as well as keep the tank and machine smelling better.
• Remove the recovery tank lid and open the drain valve.
• Place a bucket under the drain valve.
• Use a hose to rinse the dirt and debris out of the recovery tank.
• Close the drain valve and spray the tank with a deodorizer or disinfectant.
• Proceed to Waste Pump Cleaning and replace the recovery tank lid.
• Dispose of the dirty water and debris.
LID – AC11D
LATCH
O-RING
FILTER BODY
FILTER BAG
–
AC11A
Repair parts are available for the Hydro-Filter:
Filter Bag: AC11A
Parts Kit: AC11B – (Includes Latch, O-ring & screws.)
Lid: AC11D