Filter
Top Products
16
7. Pressure Adjustment:
When the high-pressure solution pump is on and primed, pressure will show on the gauge only while the tool
is being sprayed. When the tool is sprayed the gauge will display the pressure being delivered to the tool.
When the tool is not being sprayed the gauge will return to zero.
• To decrease the pressure, turn the black knob on the pressure regulator to the left (counter-
clockwise.)
• To increase the pressure, turn the black knob on the pressure regulator to the right (clockwise.)
• To adjust pressure to your tool and surface requirements:
o Spray the tool.
o Check the pressure on the gauge.
o Re-adjust as needed to set the machine at the desired pressure.
o Choose the pressure setting that best meets your type of cleaning.
Pressure gauge
To increase the solution pressure, turn the
regulator knob clockwise.
To decrease the solution pressure, turn the
regulator knob counter-clockwise.
The maximum pressure setting is 1200psi;
however, the highest pressure attained is
dependent on the amount of water flow at the
tool:
• Smaller jets and lower flow will allow for
higher pressure at the tool.
• Larger jets and higher flow will lower the
maximum pressure attained at the tool.
The desired setting will depend on the type of
cleaning and tool used. For example:
• Carpet Cleaning with 2-jet AW29 wand: 400psi
• Tile Cleaning with SX-12: 1000psi
If adjusting or maintaining pressure becomes a
problem, refer to the trouble shooting guide or
contact your distributor for advice or assistance.