Filter
Top Products
24
OLYMPUS SWITCH PANEL:
Vacuum #2 – Power from Cord #1.
When the switch is turned to the ON
position power is supplied to the vacuum
motor. (2-Stage Vacuum)
Solution Pump Switch – Power from Cord #2.
When the switch is turned to the ON position
power is supplied to the solution pump motor.
When not using solution (Extracting Only) do not
turn this switch ON.
Waste Pump Switch – Power from Cord #2.
When switch is turned to the ON position,
Waste Pump operation is controlled by the Float
Switch in the Recovery Tank. Pump will remain
off until water level rises to the point at which
the float switch will turn the Waste Pump ON.
Do not turn Waste Pump Switch ON unless a
hose is connected to the Pump-out Outlet port.
Vacuum #1 – Power from Cord #1.
When the switch is turned to the ON
position power is supplied to the vacuum
motor. (3-Stage Vacuum)