Filter
Top Products
17
W415-0619 / B / 03.03.08
LK8 LIGHT INSTALLATION (OPTIONAL)
1. Turn off the electrical and gas supply to the fi replace.
2. Remove the frame from the unit by removing the 2 black securing
screws from the top, and the 2 silver hex head securing screws from
the bottom.
3. Lay the frame down on its front, being careful not to scratch the
fi nish.
4. Starting at the top of the frame, take one light assembly and carefully
snap it into place in the hole provided. Repeat for each of the light
assemblies. The wires on the top 2 light assemblies will need to be fed
in behind the heat shields.
Note: When installing the light kit be careful not to scratch your
fi ngers on any of the exposed screws in the frame.
5. Using Figure 31 as a guide, connect the light assemblies to the
appropriate fl ags on the wire harness. The wire harness is labeled (TR)
top right, (BR) bottom right (TL) Top left and (BL) bottom left.
6. Secure the wires into the clips at both sides and the bottom of the
frame. Use the extra clips provided to retain any loose wires.
7. Re-attach frame onto unit.
8. Remove the control panel by removing the 2 screws securing it along
the top edge. Leave the wires connected to the ON/OFF switch.
9. Place the transformer into the bottom of the unit. Plug the transformer
into the receptacle.
10. Lay the control panel fl at along the bottom edge of the frame. Attach
one of the wire leads from the transformer to the lead on the wire harness
labeled “TRANS”, and the other to the ON/OFF switch. Attach the last
lead on the wire harness labeled “SWI” to the ON/OFF switch.
11. Re-secure the control panel.
12. Turn on the gas supply and electrical power.
SW
I
T
R
A
N
S
TR
TL
BR
BL
CLIPS X5
ACCENT GLASS INSTALLATION
Carefully sprinkle the accent glass onto the glass support
evenly. Ensure no glass falls into the burner area. If this
happens, insert a clean bag into your vacuum cleaner and
vacuum out the accent glass. Replacement accent glass
can be purchased from Wolf Steel Ltd.
GLASS
SUPPORT
ACCENT
GLASS
BURNER
FIGURE 30
FIGURE 31