Napco Security Technologies GEM-X255 Home Security System User Manual


 
22
PROGRAMMING (OPTIONAL)
Enter the User Program Mod
e
1
Enter your User Code, then press
A
to enter the Function Mode.
2
Answer NO (
F
)
until
“ACTIVATE PROGRAM Y/N” is displayed
, then
press YES
(
E
)
“ENTER USER CODE” will display indicating that the
system is ready for User Code programming.
Programming / Reprogramming a User Cod
e
1
Enter the
3 digits of the user number to be programmed, followed by
AA
.
( Example: for User 4, enter 004
AA
).
2
Enter the new User Code (up to 6 digits)
3
Press
D
to save the new User Code.
Repeat Steps 1 through 3 for each User Code to be programmed.
Erasing a User Code
1
Enter the
2 digits of the user number to be erased followed by
AA
.
2
Press
G0
to erase each digit of the User Code and then press
D
.
Example: Erase User 3’s 4-digit User Code:
Press
03 AA
G0 G0 G0 G0 J
.
User Program Mode
Your Installer has programmed into your system a special User Program Code which can be used to not only Arm and Disarm
the system, but also to enter the User Program Mode, where you can program other User Codes, Zone Descriptions and also
set the system Time and Date. The following explains how you will use this code to program or erase additional User Codes:
ACTIVATE
PROGRAM Y/N
ENTER USER CODE
001 1
23 - -
ENTER USER CODE
0
04 - -
ENTER USER CODE
004 4
567 - -
GEM-X255_OI273_USER.pub
page 22
Tuesday, September 10, 2002 13:14