Filter
Top Products
11
FIRE PROTECTION
(Applicable only where local ordinance permits use of this alarm control panel for fire protection.)
Fire-Zone Alarm
If a fire is detected, “FIRE ALARM” will be displayed and the keypad sounder will pulse.
1
If a fire is in progress, evacuate the premises immediately! If necessary, call the Fire
Department from an outside phone.
2
Press the C button to silence the keypad sounder.
3
If there is no evidence of a fire, enter your User Code and press
J
to turn off the alarm.
4
Check smoke detector(s). If a smoke detector tripped, its red alarm indicator light will be
on.
5
After the alarm condition is corrected (thermostat cooled down; smoke cleared from
detector; etc.), pressing
C again will reset the keypad within about 10 seconds.
NOTE:
When the Fire Zone is reset, the FIRE icon on the left side of the display will go
out. If the FIRE icon is still displayed, the fire zone has not been properly reset. If you
cannot clear this condition by pressing
C, call for service.
Fire-Zone Trouble
1
If a problem in the fire-circuit is detected, “FIRE TROUBLE” will display and the sounder
will pulse to signal a malfunction.
2
Press C to silence the sounder. Call for service immediately!
FIRE
FIRE ALARM
FIRE
FIRE TROUBLE
GEM-X255_OI273_USER.pub
page 11
Tuesday, September 10, 2002 13:14