Filter
Top Products
MAYCO LS600 PUMP — OPERATION AND PARTS MANUAL — REV. #4 (9/15/11) — PAGE 31
It will be necessary at times to move your pump from
one job site location to another. Before moving the
pump, make sure to pump the remaining concrete out
of the hopper. Moving the pump with a
full hopper
of
concrete can cause
severe damage
or breakage of
the axle and axle springs, excess strain and pressure
on the hub and bearing assembly.
WARNING - TRANSPORTING PUMP
Leaking manifold seals or hose coupling
gaskets which leak water can cause sepa-
ration and subsequent jamming at that point.
LS600 PUMP — OPERATION
Radio Remote Control Programming
Before starting operation of the Radio Remote Control, go
to Screen 9 of the Digital Readout Screen:
1. Press the ON/OFF button on the radio (wireless) remote
control to turn on the power. Hold down the RESET switch.
The display will now show:
2. After 5 seconds, the display will show:
3. The remote control is now ready for use.
Cable Remote Control
Installation of the Cable Remote Control Assembly
Connect the cable to the front panel of the control box
(See Figure 38).
RADIO ADDRESS
NO RADIO
PRESS RESET TO
LEARN A NEW ONE
9
RADIO ADDRESS
NOW SCANNING
FOR NEW
TRANSMITTER
9
RADIO ADDRESS
COMMUNICATING
PRESS RESET TO
LEARN A NEW ONE
9
CABLE REMOTE CONTROL UNIT
CABLE REMOTE CONTROL UNIT
25 FT. CABLE
25 FT. CABLE
PUMP REV
PUMP ON/OFF
TO CONTROL BOX
CONNECTOR
TO CONTROL BOX
CONNECTOR
Figure 38. Cable Remote Control
Cable Remote Control Operation
Before using cable remote control, set the pumping volume
with the VOLUME switch on the control box then move the
Pumping Control Switch on the control box to the REMOTE
position.
The cable remote control (Figure 38) has the following
controls.
PUMP ON/OFF - Starts and stops the forward pumping.
PUMP REV - starts pumping in reverse direction.