Filter
Top Products
MOXA AirWorks AWK-1200-AP User’s Manual Web Console Configuration
3-12
LAN Computers
This area of the screen continually updates to show all DHCP enabled computers and devices
connected to the LAN side of your Access Point. The detection “range” is limited to the address
range as configured in DHCP Server. Computers that have an address outside of this range will not
appear. If the DHCP Client (i.e. a computer configured to “Automatically obtain an address”)
supplies a Host Name then that will also be shown. Any computer or device that has a static IP
address that lies within the detection “range” may show, however its host name will not.
Wireless
The wireless section allows you to view the wireless clients that are connected to your wireless
Access Point.
MAC Address
The Ethernet ID (MAC address) of the wireless client.
IP Address
The LAN-side IP address of the client.
Mode
The transmission standard being used by the client. Values are 11a, 11b, or 11g for 802.11a,
802.11b, or 802.11g respectively.
Rate
The actual transmission rate of the client in megabits per second.
Signal
This is a relative measure of signal quality. The value is expressed as a percentage of theoretical
best quality. Signal quality can be reduced by distance, by interference from other radio-frequency
sources (such as cordless telephones or neighboring wireless networks), and by obstacles between
the Access Point and the wireless device.