Filter
Top Products
MOXA AirWorks AWK-1200-AP User’s Manual Getting Started
2-4
What to Check before You Install the AWK-1200-AP
Before installing the AWK-1200-AP for outdoor applications or hard-to-reach locations, we
recommend configuring and testing all devices first.
For configuring the AWK-1200-AP, please follow the steps below to power up the
AWK-1200-AP (refer to Figure 2-4).
Step 1:
Connect the DC plug of the AC/DC power adapter into the DC Input Port of the Inline Power
Injector and the wall-mount plug into a power outlet or power strip (refer to page 2-2). The Power
LED on the Inline Power Injector will light up.
Step 2:
Run the cross-over Ethernet cable from the Data Input Port (refer to page 2-2) to the Ethernet
port on a PC.
Step 3:
Connect the 30 m CAT 5 Ethernet cable to the AWK-1200-AP. Hand tighten the connector.
Step 4:
Connect the other end of the 30 m CAT 5 cable to the PoE labeled POWER & DATA OUT. This
is the power side of the PoE that will power up the AWK-1200-AP.
When the AWK-1200-AP receives power over the Ethernet cable, the AWK-1200-AP will start
the boot up sequence, and the Active LED on the Inline Power Injector will light up.
You can use a web browser, such as Microsoft Internet Explorer or Netscape Navigator, to
configure the AWK-1200-AC from a remote host or PC.
Figure 2-4