Moneual Lab H67 Pro Vacuum Cleaner User Manual


  Open as PDF
of 60
 
51
Customer Support
Troubleshooting
Problem Solution
If the RYDIS H67 Pro does not work or
if the power is not turning on.
tTurn on the system power switch at the lower-rear side of the RYDIS H67 Pro.
tCheck the battery level lamp on the control panel.
tCharge the battery if the battery level is low.
If the RYDIS H67 Pro does not charge.
t   
Clean the charging terminals on the bottom of the RYDIS H67 Pro and the
charging station.
t$IFDLJGUIFDIBSHJOHMBNQJTMJUVQCMVFGPSQPXFSPOBOESFEGPSDIBSHJOH
If not, then check if the power cord is connected to the charging station.
t5VSOPOUIFTZTUFNQPXFSTXJUDIBUUIFSFBSPGUIF3:%*4)1SP
t:PVDBOBMTPDIBSHFUIF3:%*4)1SPCZDPOOFDUJOHUIFQPXFSBEBQUPS
directly to the power jack at the rear side of the robot vacuum cleaner.
If the RYDIS H67 Pro does not return
to the charging station.
t   
Check the power connection and make sure blue lamp is on.
t   
Make sure the charging station is installed to the wall solidly.
t   
Make sure the location of the charging station is an open area.
See page 16 for Installing the Charging Station.
t   
Clear all obstacles around the charging station.
t   
Install the charging station on hard oor when mop is attached.
If the remote control does not work.
tTurn on the system power switch at the rear side of the RYDIS H67 Pro.
t   
Replace the batteries on the remote control.
If the suction power is weaker than
normal.
t
Empty the dust bin.
t
Clean the lter of the dust bin.
t
Check if there is anything blocking the dust inlet.
t
Check if the Turbo option is on. If the Turbo option is on, it will provide more
suction power.
If the main brush does not rotate.
t   
Check if there is anything tangled in the main brush.
t   
Make sure the main brush has been installed properly.
If the side brushes do not rotate.
t   
Check if there is anything tangled in the side brushes.
t   
Make sure the side brushes have been installed properly.
If the operational noise is louder than
normal.
t   
Check if there is anything tangled in the main brush.
t   
Make sure the main brush has been installed properly.
t   
If the Turbo option is on, that can generate more noise.
 previous next