Filter
Top Products
40
RYDIS H67 Pro
Cleaning the Dust Filter
1
2
Clean the dust lter.
(Remove dust from each of the four
lters by blowing.)
Remove the dust lter.
Ě
The dust lter can be easily cleaned by gently scraping o the surface or compressed air.
The dust lter is reusable.
It is recommended not to clean with water.
Ě
We recommend that you clean the dust lter whenever the bin is more than 2/3 full.
If you do not clean the dust lter, the suction power of the RYDIS H67 Pro can be reduced.
Ě
Replace the dust lter if you notice a tear or a hole.
The lifetime of a dust lter is about 3 months for normal use, but may vary depending on the frequency and
operating environment.
Ě
Applying excessive force will damage the dust lter cover while disassembling the dust lter.
Ě
If you assemble the lter incorrectly, the performance may be degraded or the suction power may be reduced.
Assemble the dust lter .
(Assemble four lters as described above)
Filter cover
Filter case
Pre lter
1
Fine mesh lter
2
Main lter
3
Mesh lter
4
3