Filter
Top Products
1
Parlor Vent Free Fireplace
FP2561
anchor screws
Anchor Screws
3/16" x 1Z\v"
FP561
Figure 10 -
Secure Heater to Floor or Hearth
Clearance requirements as detailed in
section
on of this manual, must be met before securing
the heater in place.
1. Open the control access door.
. Remove five (5) screws holding engine base to unit.
3. Slide engine assembly forward out of unit.
4. Secure the firebox with two () anchoring screws (3/16"
x 1Z\v" length) supplied with fireplace.
FP2560
remove burner
Screws
FP560
Figure 9 -
Remove Engine Assembly
Screws
Engine
Assembly
1. Remove arched brick liner from packaging.
. Remove two () screws holding light fixture to bracket
attached to burners.
3. Carefully lay light fixture onto burner top.
4. Carefully pick up brick liner with two hands and tilt top
of liner away from unit.
5. Place bottom of liner into firebox behind burner and pilot
assembly. Be careful not to bend or break fuel line to
pilot.
6. Once bottom of liner is in place, gently push top in
place.
7. Gently center liner in firebox.
8. Replace light fixture to bracket.
Installation complete.
The arched brick liner should be leaning forward
until decorative face is in place. Refer to
FP2554
remove light fixture
Light
Fixture
Screws
FP554
Figure 11 -
Place Light Fixture on Burner Top
FP2555
firebrick panel
Figure 12 -
Firebrick Panel
FP555