Filter
Top Products
90
6
Select mode No. 02
(room temperature detection position).
7
Select setting No. 03 (remote controller fixed).
(Use
F
and
G
.)
8
Enter the setting.
(Press
E
.)
Finished
0
End function display.
(Press
A
and
B
at the same time.)
Example:
Selecting room temperature
detection position
YES
YES
NO
NO
9
Selecting functions using the wired remote controller
1
Check the function selection setting.
For modes 15 and higher,
press
J
and
B
at the same time.
3
Specify refrigerant address 00 (outdoor unit).
4
Specify unit No. 00. (indoor unit)
(Use
C
and
D
.)
5
Enter the setting.
(Press
E
.)
(Specified indoor unit:
FAN operation)
Change refrigerant
address or unit No.
2
Switch to function setting mode.
(Press
A
and
B
at the same time
with stop the remote controller.)
12-1-1. Selecting functions using the wired remote controller
First, try to familiarize yourself with the flow of the function selection procedure. In this section, an example of setting the room
temperature detection position is given.
For actual operations, refer to steps 1 to 0.
Setting number
Refrigerant address Unit number
Mode number
F
E
G
C
D
J
B
A
I
Modes 01 to 14 can be activated
by pressing buttons
A
and
B
simultaneously, and modes 15 to
28 by pressing buttons
B
and
J
.
The above procedure must be carried out only if changes are necessary.
OCH429--3.qxp 07.11.20 9:19 AM Page 90