Filter
Top Products
screw
side panel
sliding the panel
to the front
27
Figure 3
5. Removing the side panel
(1) Remove the air intake grille.
(2) Remove the screw from the side panel, and remove the
side panel by sliding the panel to the front.
OPERATING PROCEDURE PHOTOS & ILLUSTRATIONS
3. Removing the fan motor <MF>
(1) Remove the intake grille.
(2) Disconnect the fan motor connector.
(3) Remove the screw for removing the motor support at both
left and right side.
(4) Loosen the set screws at the fan motor side of the con-
necting joint.
(5) Slide the fan motor <MF> to the left side and pull it out.
4. Removing the sirocco fan
(1) Remove the air intake grille.
(2) Remove 1 beam.
(3) Remove the lower casing while pressing the stoppers at
upper side of the casing.
(4) Loosen the set screws at the connecting joint.
(5) Remove the sirocco fan and shaft together by sliding the
shaft to the left.
(Note)
Make sure that the upper side casing is snapped to the fan
plate securely with catch.
Photo 2
Photo 3
Motor set screws
Motor support
connecting joint
Sirocco fan
Shaft
Motor
Set screw
Catch
Connecting joint
Bearing
Screws
Screws
Casing
OC368B--1.qxp 07.6.20 1:01 PM Page 27