Filter
Top Products
INSIDE VERTICAL INSTALLATIONS:
Figure 14: Inside Vertical Installation.
1. Choose a stove location that is ideal.
See the section “DECIDING WHERE TO
LOCATE YOUR PELLET APPLIANCE.”
2. Place a non-combustible hearth pad
where necessary.
3. Place the unit on the hearth pad (if
installed on a combustible surface)
and space the unit in a manner so
when the pellet vent is installed
vertically, it will be 3” (7.5 cm) away
from a combustible wall.
4. Install the tee with clean out.
5. Install the pellet vent upward
from there. When you reach the
ceiling, make sure that the vent
goes through the ceiling fire stop.
Maintain a 3” (7.5 cm) distance
to combustibles and keep attic
insulation away from the vent pipe.
Maintain an effective vapor barrier.
6. Finally, extend the pellet vent to go
through the roof flashing.
7. Ensure that the rain cap is
approximately 24” (600 mm) above
the roof.
12
Wall framing
Wall thimble
Termination cap
Vertical section
of vent pipe
Horizontal frame
for thimble
90° elbow
Concrete Wall
Clean out tee
Wall framing
Wall thimble
Termination cap
Vertical section of vent pipe
Horizontal frame for thimble
Clean out tee
90° elbow
Wall strap
Figure 12: Venting horizontally with rise. Figure 13: Venting with concrete wall behind unit .
Installation