Marmitek MS9470 Home Security System User Manual


 
30 MARMITEK
Your SC2800 base station is equipped with a dial-in function. You now can control your security system from every touch
tone phone or mobile. You also can control lights and appliances over the phone. Your phone must be capable of touch
tone (DTMF) dialling. Most mobiles have this as a default setting. If not, you can activate DTMF dialling via the menu of your
mobile. Your lights and appliances have to be connected to Marmitek X10 Home Automation Modules. For more
information, go to www.marmitek.com.
1. SETTING THE PHONE LINE PICK UP TIME
You can set the time it takes for the base station to answer an incoming call. The factory default is 30 seconds. When you
are using services like voice mail, an answering machine, etc., you may want to set the line pick up time shorter (15 sec).
The dial-in feature can also be disabled.
To set the phone line pick up time:
1. Set mode switch to INSTALL: All indicators of occupied zones come on
2. Enter your 4 digit PIN code (factory default [0000] refer to 5.8): One confirmation beep at every key press
3. Press key number 3: One short confirmation beep
4. Press ENTER: One short confirmation beep
5. You can now choose 1 of 3 options:
Press 0 for a pick up time of 30 seconds
Press 1 for a pick up time of 15 seconds
Press 2 for disabling the dial-in function: Short double confirmation beep
6. Reset mode switch to RUN 1 or RUN 2 position: Zone indicators go out
2. ARMING AND DISARMING VIA THE TELEPHONE
As soon as the base station answers your call, you can arm or disarm the security system.
Arming and disarming the system:
1. Call the base station from a touch tone or mobile phone.
2. The base station will answer your call with 3 short beeps
3. After these beeps, enter your PIN code via the phone (factory default [0000] refer to 5.8).
4. The base station confirms a correct PIN code with 3 short confirmation beeps
(an erratic PIN code is indicated by one long beep).
5. You now can select the ARM AWAY mode by entering 0 followed by a *. You’ll hear 3 short confirmation beeps.
6. You can disarm the system by entering 0 followed by a #. You’ll hear 2 short confirmation beeps.
3. SWITCHING LIGHTS OVER THE TELEPHONE
As soon as the base station answers your call, you can control lights and appliances with Marmitek X-10 Home Automation
modules over the phone.
1. Call the base station from a touch tone or mobile phone.
2. The base station will answer your call with 3 short beeps.
3. After these beeps, enter your PIN code via the phone (factory default [0000] refer to 5.8).
4. The base station confirms a correct PIN code with 3 short confirmation beeps
(an erratic PIN code is indicated by one long beep).
5. Switch ON lights or appliances connected to a module by entering it’s Unit Code (e.g. 12) followed by a *.
You’ll hear 3 short confirmation beeps.
6. To switch OFF lights or appliances connected to a module, enter it’s Unit Code (e.g. 12) followed by a #.
You’ll hear 2 short confirmation beeps.
7. SC2800 DIAL-IN FEATURES