Marmitek MS9470 Home Security System User Manual


 
26 MARMITEK
A panic alarm can be activated at any time in case of an emergency, regardless if the system is armed or disarmed.
You can activate a panic alarm in three ways:
Using the SC2800 base station:
Press the red PANIC button: The panic alarm will be activated without any delay. Depending on the SC2800 setting, the siren
will sound or not (refer to 5.3).
Using the SH624 system remote control:
Press the red PANIC button: The panic alarm will be activated without any delay. Depending on the SC2800 setting, the siren
will sound or not (refer to 5.3)
Using the KR21 key chain remote control:
Press the 2 red PANIC buttons simultaneously: The panic alarm will be activated without any delay. Depending on the
SC2800 settings, the siren will sound or not (refer to 5.3)
The zone indicator panel gives the status of the registered sensors.
INDICATOR FLASHES SLOWLY:
The base station did not receive a message from that sensor for quite a while. Replace the batteries of the sensor. If that
does not correct the problem, re-register the sensor (refer to 5.1).
INDICATOR FLASHES RAPIDLY:
The zone is cancelled by pressing the BYPASS button when you last armed the system (6.2).
ZONE INDICATOR IS ON, ARM INDICATOR FLASHES:
This zone initiated the most recent alarm situation.
INDICATOR IS ON IN DISARM MODE:
The door or window protected by the DS10 is open.
6.7 ZONE INDICATORS
6.6 PANIC ALARM