Marmitek MS9470 Home Security System User Manual


 
Controls
1 Battery Indicator
When pressing the TEST key or when a signal is
transmitted, the indicator light will blink. If it only
lights up weakly, the battery needs to be
replaced.
2 TEST key
Used for setting the GB 10’s system and
transmission codes. Also used when the system is
being set up for the first time.
3 Sensitivity switch
Sets the alarm threshold for response to breaking
glass. Position "1" is high sensitivity, "2" is low.
4 Battery compartment
Insert 2 x 1,5 V batteries (AAA).
5 Microphone
This picks up and recognizes the typical frequency
of breaking glass, and activates the alarm.
6 Dusk Sensor
Activates the Life style program in the SC
2200/2700 control unit when the pre-set
threshold level of darkness is reached.
7 Antenna
A small plastic tube is supplied with the sensor.
Place it over the wire aerial and press it into the
holder on the top side of the GB 10.
Installation and start-up
1 Inserting the batteries
Open the battery-compartment at the front.
Insert the 2 batteries observing the polarity
indicated in the unit.
Close the battery-compartment.
Note: The code settings are maintained when
replacing batteries. In case the sensor looses
contact with the base console, the sensor has to
be re-registered with the system.
2 Activating the GB 10
Open the battery-compartment at the front side
of the unit.
Press the TEST key for longer than one second.
The red indicator light will flash twice.
3 Registering the sensor with your security
system
Set the mode switch on the security console to
INSTALL
Press the TEST button on the GB10 sensor
Reset the mode switch to RUN1 or RUN2
4 Setting the system address (light
control/life style function)
Press and hold the TEST key unit, the indicator
light will light continuously.
Press the TEST key the number of times that
corresponds to the system address you are
setting, e.g. 5 times for address "E", 12 times for
address "L".
After 5 seconds the LED will flash the same
number of times you pressed earlier.
13MS9470/MS9770/MS9970
2
7
3
4
6
5
1