Lowrance electronic EP-80R TH Thermostat User Manual


 
26
Unconfiguring a Temp Sensor
You could unconfigure a temp sensor by changing its temp type to un-
known or you can use the Restore Defaults command, which will reset
the temp type and device name to default settings.
To restore default settings:
1. Press
MENU twice, select NMEA 2000 or NETWORKING and press ENTER.
A menu will appear with five options: Bus Setup, Fuel Management,
NMEA 2000 Alarms, Waypoint Sharing and Backlight Synchroniza-
tion.
2. Highlight
BUS SETUP and press ENTER, which will open the Bus Con-
figuration menu. A list of network devices will be at the top of the page.
3. Select the desired temp sensor and press
ENTER. The Device Con-
figuration menu will appear.
4. Highlight
ADVANCED OPTIONS and press ENTER.
5. Select
RESTORE DEFAULTS and press ENTER. The following message will
appear: Are you sure you wish to change this device's configuration?
6. Highlight
YES and press ENTER. Press EXIT repeatedly to return to
the main display.
Reconfiguring a temp sensor
A temp sensor can be reconfigured by changing its temp type. If the
desired configuration name is already configured to another temp sen-
sor, you can unconfigure that sensor to make its configuration name
available.
To change Temp Type:
1. Press MENU twice, select NMEA 2000 or NETWORKING and press ENTER. A
menu will appear with five options: Bus Setup, Fuel Management,
NMEA 2000 Alarms, Waypoint Sharing and Backlight Synchroniza-
tion.
2. Highlight
BUS SETUP and press ENTER, which will open the Bus Con-
figuration menu. A list of network devices will be at the top of the page.
3. Select the desired temp sensor and press
ENTER. The Device Con-
figuration menu will appear.
4. Highlight
TEMP TYPE and press ENTER. The following options will ap-
pear: Water, Outside, Inside, Engine Room, Cabin, Live Well, Bait
Well, Refrigeration, Heating System and Unknown.
5. Highlight the desired Temp Type and press
ENTER. The following
confirmation message will appear: Are you sure you wish to change this
device's configuration?
6. Highlight
YES and press ENTER. Press EXIT repeatedly to return to
the main display.