10
3. If you selected a configuration with more than one tank you will have
to select the tank you want to set up and press
MENU, which will open
the Tank Size window. (If you choose a single-tank configuration, you
will not have to choose the tank. You will be directed straight to the
Tank Size window covered in Step 4.)
4. Use the
UP and DOWN keys to input the number of gallons the tank
will hold and press
MENU. Repeat steps 3 and 4 for each additional
tank. After all tanks have been set up, you will be directed to the main
display.
Boat Setup Reset
If you want to access the Setup screen (Boat Setup) after an engine-
tank configuration has been chosen you will have to reset the configu-
ration to default settings.
To reset engine tank configuration:
1. Press MENU, highlight SYSTEM SETUP and press MENU.
2. Choose
ENG/TANK and press MENU twice. The following message will
appear: Hit menu to reset Eng/Tnk.
3. Press
MENU. The Setup screen will appear with Boat Setup high-
lighted.
EP-80R TH Configuration
The EP-80R TH temperature sensor has three configuration options:
Inside, Outside and Water. An unconfigured temperature sensor will
appear on the Bus Devices list as UnCfg Temp.
To configure a temp sensor:
1. Press MENU, use the UP and DOWN keys to select SYSTEM SETUP and
press
MENU.
2. Highlight
B. DEVICES and press MENU. After a few moments the Bus
Devices list will appear.
3. Highlight
UNCFG TEMP and press MENU. The following message will
appear: Hit Menu to Cfg Temp Sns.
4. Press
MENU to be taken to the Selecting Temp menu, which will have
three options: Inside, Outside and Water.
5. Highlight the desired temp option and press
MENU. The temp sensor
has now has been configured. You will be directed to the Bus Devices
list.
NOTE:
If your temp sensor is not updated on the Bus Devices list, refresh
the list by letting it time out and then access it again.