Filter
Top Products
INSTALLATION
PAGE 9
DOOR OPERATION
After setup of the logs and embers is complete, the glass
door must be closed. The glass door is mounted on
hinges at the left side of the firebox and is secured in the
closed position by two draw latches mounted on the right
side of the firebox. The latch tension is preset at the
factory. Over time, adjustment of the latch tension may
be necessary to maintain a tight door seal. This adjust-
ment can be made by spinning the latching rod in the rod
guide. Care should be exercised to not adjust the ten-
sion too high. Caution: Never operate the appliance
with the glass door open.
If glass door removal is required for replacement or
maintenance, the door can be removed Do not attempt to
remove or replace broken glass in the door assembly.
Contact your Lennox dealer for glass replacement. To
Remove Door:
1. Remove the glass door assembly from appliance
as follows:
a. Open the right and left side panels (held closed
by magnets in the front. The panels hinge to
back).
b. Open the two draw latches mounted on the right
side of the door by pulling them forward. Swing
open door. See picture in left column of this page
showing their location.
c. With the door open, lift the door straight up and
off the hinge pins. Set door aside.