Filter
Top Products
SPECIFICATIONS: Model L30 BF-2
PAGE 22
Approx. Sq. Ft.
Heating Capacity ∼
∼∼
∼1500 sq. ft.
Flue Size 4” - Top Vent
Height Overall 29”
Height to Flue
Outlet 30 3/8”
Width 29 7/8”
Depth 16 1/8”
Fuel Natural Gas (standard)
(or) LP Gas (convertible).
Gas inlet 3/8” NPT-Male / Flex Line
(or) remove flex, 3/8” NPT–Female Flare.
Performance Variable Flame Control.
Features High Efficiency Heat Exchanger.
Natural Convection & Radiant Heat.
Standing Pilot / Operates During Power
Outages. Remote Control & Wall
Thermostat Capable.
Technical Honeywell Combination Gas Control
Features Valve, Millivolt - VS8520E. Safety Shut
Down Sensor (Spill Switch).
Pan Burner with Tuned Ports.
Radiant & Fan Assisted Convection
Heat.
Safety Test Tested and certified by CSA to ANSI
standards. Z21.88 – (1998) •
••
• CSA 2.33 -
(1998). Vented Gas Fireplace Heater .
Heat Input 25,000 to 37,000 BTU’s (Nat. Gas)
28,000 to 35,000 BTU’s (Propane)
Ship Weight 200 lb.’s
Dimensions shown are approximations only (+ / - ¼”)
Top View
Side View
~ Square feet heating capacities are approximations only.
They will vary depending upon level of insulation, climate,
house design, ceiling height, ambient outside tempera-
tures and how stove is operated.
SPECIFICATIONS
GAS TYPE NATURAL
GAS
PROPANE
(LP)
CLEARANCES TO COMBUSTIBLES
Orifice Size #31 -.120 #50-.070” Back Wall Min. 2 In. / 51 mm
Minimum Supply Pressure 4.5” WC 10.5” WC Side Wall Min. 12 In. / 305 mm
Maximum Supply Pressure 10.5” WC 13.0” WC Corner (45°
°°
° angle)s
HIGH SETTING stove corner to wall, min. 4 In. / 102 mm
Manifold Pressure 3.5” WC 10.0” WC Ceiling Height Minimum 65 In. / 1651 mm
Input BTU / HR 37,000 35,000 Alcove Min. Height 65 In. / 1651 mm
LOW SETTING Alcove Min. width 54 In. / 1372 mm
Mainfold Pressure 1.8” WC 6.6” WC Alcove - Max. Depth into
Input BTU / HR 25,000 28,000 stove face to alcove opening 24 In. / 610 mm
♦
♦♦
♦ Altitude - U.S.A. 0-4,500 Ft. (0-1372M) No derating
♦
♦♦
♦ Altitude - Canada 0-4,500 Ft. (0-1372M) No derating
For installation higher than altitudes shown above, reorifice per Gas
Codes.
* With the orifice, manifold pressure and input
ratings shown above.
This Appliance is equipped at the factory for the use with Natural Gas or Propane (LP). Appliances using propane must
be field conversed using the LP Conversion Kit supplied with appliance.