Filter
Top Products
8
NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE.
Figure 12
Proper log placement is critical to prevent
sooting. Carefully position the ceramic fiber
logs over the burner as described in the fol-
lowing steps, and detailed in
Figures 11
through 15
.
Note: Logs should be placed in the gaps be-
tween the flame peaks and should be posi-
tioned so that at no time they impinge the
flames.
Step 1. Remove the rockwool from the pack-
aging and tear into nickel size pieces. Spread
the rockwool evenly on top of the burner. Do
not use more than is necessary. The rockwool
should not cover the burner ports, as shown in
Figure 10.
Step 2. Place the hole at the bottom of the
Rear Log over the pin at the rear of the log
grate, as shown in
Figure 11
. The log should
rest against the back refractory.
Step 3. Place the Rear Top Log over the left
side of the Rear Log. Lay the log over the top
left corner of the Rear Log, as shown in
Figure 12
. The log should rest against the
back refractory.
Figure 13
Logs and Rockwool Placement
Figure 14
WARNING: LOGS GET VERY HOT AND
WILL REMAIN HOT UP TO ONE HOUR
AFTER GAS SUPPLY IS TURNED OFF.
HANDLE ONLY WHEN LOGS ARE COOL.
TURN OFF ALL ELECTRICITY TO THE
APPLIANCE BEFORE YOU INSTALL
GRATE AND LOGS.
WARNING: THIS APPLIANCE IS NOT
MEANT TO BURN WOOD. ANY ATTEMPT
TO DO SO COULD CAUSE IRREPARABLE
DAMAGE TO YOUR APPLIANCE AND
PROVE HAZARDOUS TO YOUR SAFETY.
WARNING: THE SIZE AND POSITION
ON THE LOG SET WAS ENGINEERED TO
GIVE YOUR APPLIANCE A SAFE, RELI-
ABLE AND ATTRACTIVE FLAME PAT-
TERN. ANY ATTEMPT TO USE A DIF-
FERENT LOG SET IN THE FIREPLACE
WILL VOID THE WARRANTY AND WILL
RESULT IN INCOMPLETE COMBUSTION,
SOOTING, AND POOR FLAME QUALITY.
Figure 11
Figure 15
Figure 10
Rear Log
Rear Top Log
Front Left Log
Front Right Log
Top Right Log
Rear Log
Step 4. Engage the bottom hole of the Front
Left Log with designated pin on the grate, and
align the bottom groove of the log over the far
left grate bar. See
Figure 13.
Step 5. Engage the bottom hole of the Front
Right Log with designated pin on the far right
grate bar. Align the groove on the bottom of the
log over the far right grate bar. See
Figure 14.
Step 6. Engage the bottom hole of the Top
Right Log, over the pin on the Front Right Log.
Rest the upper portion of the log in the notch
of the Rear Log. See
Figure 15
.
Front Right Log Pin
Notch In Rear Log
Front Right Log Pin
Burner Ports
Rockwool
Rear Log Pin