Filter
Top Products
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE
8
Removing Appliance From Pallet
1. After removing the packaging from the stove, lift the hopper lid, and
remove all prepackaged items that were shipped in the hopper. Next,
open the stove door and remove all prepackaged items.
2. With the stove door open, remove the ash drawer and set aside. Using
a 7/16” socket or open end wrench, remove the front lag screw (see
Figure 5A
).
3. Using a 5/32" allen wrench remove the two screws in the rear pallet
bracket (see Figure 5B). Using a 7/16” socket or open end wrench,
remove the rear lag screw (see Figure 5B).
INSTALLATION
Front Lag Screw
(actual size)
Rear Lag Screw
(actual size)
Pallet
Pallet
SEE DETAIL B
DETAIL B
SEE DETAIL C
DETAIL C
Rear Pallet
Bracket
Rear Lag Screw
Front Lag Screw
Figure 5A - Front Lag Screw
Figure 5B - Rear Lag Screw and Pallet Bracket
Installation Check List
It is strongly recommended that you have an Lennox Hearth Products
dealer install your stove. If you install your stove yourself, you should
review your installation plan with an Lennox Hearth Products dealer.
Check list:
Check off each item as you proceed with the installation process.
q Read the ENTIRE stove installation section first
q Determine the appropriate measurements and locations for your
installation.
q Follow the installation directions in this manual.
q Be sure to prefit all items before you install, fasten, or set up the
appliance permanently.