Filter
Top Products
17
CARE AND OPERATION
Simple Operating Instructions
3. Priming the Auger
(Optional)
a] Fill hopper with pellets
Note: use quality grade pellet
fuel
b] Push the "START" button
to turn on the blowers and
auger motor
e] When pellets begin to
drop from feed tube into
UltraGrate, push the "STOP"
button to stop the auger
1. Start
4. Stove is now ready for
start-up
5. To Start Your Stove
a] Push the "START" button.
Note: Room air blower and
exhaust blower start w/ line
voltage for 10 seconds, then
return to settings when last
operated.
6. Pellets will drop into
UltraGrate and stove will
light in approximately 3
to 7 minutes
Does the Stove Light?
7. Set stove to desired
heat setting (heat output
button). The new setting
will not take effect until the
switch receives adequate
heat to activate.
8. After approx. 5 minutes
adjust damper if neces-
sary to obtain a bright
vibrant flame.
Notes:
• If the damper is too far
inward the flame will be
lazy/sooty and the fuel will
pile up in the UltraGrate
(see Page 9).
• If the damper is too far
outward the flame might
be extinguished because
of too much combustion
air.
See Page 19 for further
instructions on adjusting
damper using thermostat vs
manual modes.
No
7a. Follow the troubleshooting
section in this manual
Contact your Lennox Hearth
Products dealer for further
assistance
10. Thank you for purchasing a Lennox
Hearth Products Pellet Stove
END
Does the Stove Light?
No
FIRST TIME USE
Heat Output
Button
Convection
(room air)
Blower
Button
9. To Turn Off Pellet Stove
a] Push "STOP" button - stove
enters shut down mode
b] Combustion blower goes to
high and room air blower will
operate at the panel setting
until low temperature switch
cools. Pellets stop feeding
and the fire goes out in
approximately 15 minutes
after the auger is shut off, the
room air blower and exhaust
blower will automatically
shut off.
2. Preparation
a] Check hopper and remove
any materials from hopper
and auger
b] Check UltraGrate™ for proper
fit (ensure UltraGrate is set
securely in the base - see
Figure 29)
c] Check door gasket and door
latch to ensure tight seal
(see Figure 33)
d] Connect power cord to
grounded power supply
outlet
Yes
Yes
START
HEAT
OUTPUT
BLOWER
FEEDING
STOP
(-) (+)
O
(-) (+)
O
COMBUSTION
AIR
PELLET
FEED
HEARTH PRODUCTS
Start Button
Stop Button