Filter
Top Products
Using a
screwdriver,
tighten the
screw.
Do not overtighten.
Overtightening could strip the screw
holes.
Do not operate the cleaner without
the screw in place,
CORD ASSEMBLY
Make sure the quick release upper cord
hook is in the upright position,, Remove the
wire tie from the power cord.
Lock the cord into
place by forcing it
into the locking
notch on the body
of the quick
release upper cord
hook as shown.
This helps keep
the power cord out
from under the
vacuum cleaner
agitator.
Power
Wrap the power cord around the upper and
lower cord hooks and lock the power cord
plug onto the power cord_
Quick
Upper Cord
Hook
Power
Lower
Cord
HOW TO START
Re_ase
UpperCord
Hook
1. Turn the
quick release
upper cord
hook to either
side and
down to
release the
power cord.
2, Release the power cord plug from the
power cord and pull the cord off the quick
re_ease upper cord hook. Check to be sure
the power cord is still locked into the lock in
the quick release upper cord hook_
3. Check to see if the cleaner has bag
installed° See DUST BAG CHANGING.
Note: To reduce the risk of electric shock,
this vacuum cleaner has a polarized plug,
one blade is wider than the
other,,This plug wil! fit in a polarized outlet
only one way. If the plug does not fit fully in
the outlet, reverse the plugo If it still does not
fit, contact a qualified technician to install
the proper outlet. Do not change the plug in
any way_
4. Plug the polarized power cord into a 120
Volt outlet located near the floor.
Personal Injury and Product Damage
Hazard
• DO NOT plug in if switch is in the
ON position. Personal injury or dam-
age could result.
• DO NOT use outlets above coun-
ters, Damage from cord to items in
surrounding area could occur,
iiii I,H i ijlllll ii I III