Filter
Top Products
Check motor safety filter frequently and
change when dirty
WARNING
Electrical Shock Hazard
Unplug power cord from electrical
outlet. Do not operate the cleaner
without the motor safety filter. Be
sure the filter is dry and properly
installed to prevent motor failure
and/or electrical shock.
Remove the dust bag as outlined in the
DUST BAG CHANGING section.
MOTOR SAFETY FILTER
ELECTROSTATIC
1. This white & grey
filter must be
replaced when dirt_
it should be replaced
regularly depending
on use conditions.
The filter CANNOT
be washed as it will
lose its dust trap-
ping ability.
Note: See PARTS AND FEATURES for
motor safety filter number.
Motor
Safety
Filter
2. If the filter, locat-
ed in the bottom of
the bag cavity, is
dirty, remove it by
pulling forward out
from under the
ribs.
3. Replace the
filter, white side
up, by sliding it
back into place
under the ribs in
the bag cavity.
Motor
Safety ,_",_t]A\'r_
Replace the bag as outlined in the DUST
BAG CHANGING section°
EXHAUST FILTER
HEPA
w.,,.RNiNG I
Do not operate without exhaust
filter.
The exhaust filter cartridge must be
replaced when dirty. It should be replaced
regularly depending on use conditions The
filter CANNOT be washed as it will lose
its dust trapping ability.
Note: See PARTS AND FEATURES for the
exhaust filter number_
Slide the exhaust
filter cover
release down°
Pull out on
exhaust filter
cover to remove
from bag cover.
Cover
ExhaustFilter j
CoverRe_ase--_
Exhaust
Filter Cover1_
Remove the
exhaust filter car-
tridge from the bag
cover°
Replace the exhaust
filter cartridge, care-
fully positioning it so
that it fits into the bag
cover The grey edge
of the filter should
be facing away from
the operator. Push
only on filter cartridge
frame, not on filter itself.
E,ha°stFi,tor LL!/
Bag
Exhaust
Replace the
exhaust filter
cover and
secure the
latch by push-
ing it upward.