Filter
Top Products
TO REMOVE DUST BAG TO REPLACE DUST BAG
Pull out on the
bag cover release
located near the
top of the bag
cover,
Grasp the dust bag
collar and pull gently,
carefully removing
the dust bag°
Throw away the used
dust bag.
Do not reuse.
Pull the bag
cover forward
and lift up.
Remove and lay
aside.
- BagHolder Check the bag
holder and the
rcaviW motor safety fit-
ter..If either is
blocked, check
TROUBLE-
Safety
Filter SHOOTING.
CAUTION
NEVER REUSE A DUST BAG.Very
fine materials, such as carpet fresh-
ener, face powder, fine dust, plaster,
soot, etc. can clog the bag and
cause it to burst before it is full.
Change bag more often when vacu-
uming these materials.
i ,11111 iiiiii i iii
Unfold the new
dust bag. Fold
the safety seal
tab on the new
dust bag away
from the open-
ing that fits on
the bag holder,
Dust
Bag
NOTE: See PARTSAND FEATURES for
bag number.
Insert the dust bag
ontothe bag holder
completely by holding
the bag collar
Place the dust bag
coIlar into position_
Tuck the bag
behind each of the Bag
four bag retention Retention
Corner
corner flaps shown Flapst
here. Be sure the
bottom and sides
of the dust bag are
completely within
bag cavity prior to
replacing the bag
cover,.
l_T!!s \ Position the
bag
Slots cover so itsposi-
_ ioning tabs fit
intothe body
positioning tab
slots_
Close the bag
cover.
Youwill hear a
distinctsnap
when cover is
securely closed.
Bag
Cover
Check to see that the dust bag is fully
enclosed in the bag cover,