Jotul GZ 550 DV II Indoor Fireplace User Manual


 
21
Logset Assembly
Unpack and arrange the five logs as outlined below.
CAUTION: The logs are fragile. Handle with care.
1. Seat Right Log (1) on the pin on the right side of
the Burner Skirt. fig. 41.
2. Set Rear Log (2) on the pins at the rear of the
Burner Skirt. This log should overlap the back of
the Right Log.
3. Set the Left Log (3) on the pins at the left side of
the Burner Skirt.
4. Set the end of Front Log (4) into the pocket at
the rear of Left Log (3). Engage the other end
with the pin in the middle of the Burner Plate.
Fig. 42.
5. Engage the upper end of the Cross-over Log (5)
with the pin in the Rear Log. Fig. 42. Set the
Cross-over Log across the top of the lower end of
the Front Log (4) as illustrated.
6. Spread a layer of ember stones evenly over the
surface of the Burner Plate. Allow for 1/4”
clearance between the stones and the inner
edge of the Burner Skirt. Avoid blocking the pilot
flame area with ember stones. See Fig. 43.
7. Replace the Glass Panel Frame: Engage the top
of the frame with the three tabs at the top of
the firebox. Push the bottom of the frame
against the firebox face and pull the Frame
Latches out to engage them with the slots in the
bottom of the frame.
Figure 41. Install Right Log, Rear Log and Left Log in
that order.
1
2
3
Figure 42. Install Front and Cross-over logs as shown.
Figure 43. Install ember stones, keeping clearance
around the pilot crossover area.
5
4
Pilot
Area