Filter
Top Products
INSTALLING THE LOG SET:
The Allagash is equipped with a one piece log set
and is packaged in bubble wrap inside the firebox.
The log set must be removed from the packaging
and arranged in the unit prior to start up of the
gas stove. Do not handle the log set with your
bare hands. Always wear gloves to prevent skin
irritation from the ceramic fibers.
To install the log set, remove the packaging and
place the log set inside the firebox, centered from
left to right and completely against the rear wall
of the stove. See Figure 8.
Embers: the stove is shipped with a package of
glowing embers. These embers should be pea
size and individually spaced across the burner
tube screen. It is best to equally space these
embers for optimum flame appearance. NOTE:
YOU DO NOT HAVE TO USE ALL OF THE
EMBERS.
THE CERAMIC FIBER LOGS AND
GLOWING EMBERS CAN IRRITATE YOUR
SKIN. IF THIS HAPPENS, GENTLY WASH
HANDS WITH WARM SOAPY WATER.
To adjust the air shutter
1.Remove the burner tube and using a phillips
head screwdriver loosen the screw at the air
shutter and adjust accordingly.
2.Be sure to retighten the screw that holds the
air shutter setting.
3.Reassemble the stove and close the door,
allow stove to burn 30 minutes on the HIGH
setting, observing the flame continuously.
4.If the flame appears weak, slow, or sooty,
repeat the process described above until the
flame is as desired.
WARNING:
AIR SHUTTER ADJUSTMENTS
SHOULD ONLY BE PERFORMED BY A
QUALIFIED PROFESSIONAL SERVICE
TECHNICIAN.
15
Figure 8
INSTALLING DECORATIVE PIPE
BRACKETS: (The use of decorative pipe is
optional and not included with the Allagash B-
Vent stove.)
To install the decorative pipe brackets on the
Allagash simply remove the four 1/4 hex head
screws holding the 4 flue collar on the stove.
See Figure 9.
It is not neccessary to remove the flue collar.
Place the L shaped decorative pipe brackets
on the flue collar and align the holes on the
brackets, flue collar, and draft hood and secure
all three with the four 1/4 hex head screws.
Black or enamel stove pipe can now rest on the
the draft hood of the appliance while the brackets
center the stove pipe over the draft hood.
Reminder: single wall stove pipe can never be
used as the vent pipe on the Allagash B-Vent
stove.
Figure 9