Filter
Top Products
INSTALLING THE OPTIONAL
BLOWER:
IMPORTANT: IF THE OPTIONAL FORCED AIR
BLOWER KIT (part # 129161) IS TO BE INSTALLED
ON THE STOVE AT THE TIME OF THE
INSTALLATION OR IN THE FUTURE, THE GAS
SUPPLY LINE SHOULD BE INSTALLED AS
CLOSE TO THE FLOOR AS POSSIBLE. USE OF A
90° ELBOW DIRECTLY OFF THE VALVE WILL
ALLOW FOR PROPER CLEARANCE FOR THE
BLOWER.
Mounting the blower:
1. Locate the reflector sheild (28) on the back of
the stove. Remove the cover plate from the
reflector shield to allow the blower bracket to
slide under the stove.
2. Locate the two raised bosses on the bottom plate
(back) of the stove.
3. The blower is mounted to the stove using these
two threaded holes.
4. With the blower bracket and sensor facing upward
align the two middle mounting holes on the bracket
with the two threaded holes on the bottom of the
stove. See Figure 10.
5. Use the two 6mm bolts to attach the blower to
the stove.
6. Be sure to tighten the bolts so that the blower is
drawn upward and tight against the stove bottom.
7. The heat sensor (thermodisc), that is already
attached to the blower bracket, should be inserted
under the stove bottom and make contact with
the firebox! See Figure 10.
16
Connecting the blower wiring harness:
1. Lift off the stove top plate.
2. Loosen (
BUT DO NOT REMOVE) the 10mm bolt
holding the switch box to the side of the stove
(left rear corner of the stove), and lift out the
switch box.
3. Remove the blank switch from the box.
(Hint: break the retaining tabs holding the
switch in the box.)
4. Insert the new HI/OFF/LO switch into the
box.
5. Connect the insulated wires from the blower
to three leads on the HI/OFF/LO switch.
BLACK wire to the HI position, WHITE
wire to the OFF position, and the RED wire
to the LO position. See Figure 11.
6. Retighten the switch box to the side of the
stove. Be sure all wires are unobstructed.
7. Replace top plate.
REMINDER:
The blower will ONLY come on when the
switch is in the Hi or Lo position and ONLY
when the sensor (thermodisc) is heated by the
stove.
(Approximately 10 - 20 minutes after the stove
has been running).
Figure 11
Middle mounting holes.
Use these holes to mount
blower.
Sensor
(thermodisc)
Direction
under the
stove.
Figure 10