Filter
Top Products
41810-01 08/20/2004 © 2004 Hunter Fan Company
12
cleaning your ceiling fan
caring for finishes
For cleaning, a soft brush or lint-free cloth should be used to pre-
vent scratching the finish. A vacuum cleaner brush nozzle can re-
move heavier dust. Surface smudges or an accumulation of dirt
and dust can easily be removed by using a mild detergent and a
slightly dampened cloth. An artistic agent may be used, but never
use abrasive cleaning agents as they will damage the finish.
caring for blades
Wood finish blades should be cleaned with a furniture polishing
cloth. Occasionally, a light coat of furniture polish may be applied
for added protection and beauty. Painted and high-gloss blades
may be cleaned in the same manner as the fan finish.
troubleshooting
Problem: Nothing happens; fan does not move.
1. Turn power on, replace fuse, or reset breaker.
2. Loosen canopy, check all connections according to the
wiring the fan section.
3. Check the plug connection in the switch housing.
4. Remove the shipping bumpers.
Problem: Noisy operation.
1. Tighten the blade bracket screws until snug.
2. Tighten the blade screws until snug.
3. Check to see if the blade is cracked. If so, replace all
the blades.
4. Be sure that the glass is secure.
5. Check and tighten the screws in the switch housing
mounting plate and in the upper and lower switch
housing.
Problem: Excessive wobbling.
1. If your fan wobbles when operating, use the enclosed bal-
ancing kit and instructions to balance the fan.
2. Tighten all blade and/or blade iron screws.
3. Turn power off, support fan very carefully, and check that
the hanger ball is properly seated.
Problem: No functions operate.
1. Replace fuse. Turn ON circuit breaker. Turn ON wall
switch.
2. Set transmitter and receiver to same jumper switch set-
ting.
3. Replace with new, alkaline battery.
Problem: Operates only at close range.
1. Replace with new, alkaline battery.
Problem: Inconsistent operation.
1. Turn OFF wall switch for 5 seconds, then turn back ON.
2. Change jumper switch settings to a different code in both
transmitter and receiver.
Problem: Fan will not reverse.
1. Select a fan speed button to start fan, then press the re-
verse button.
If you need parts or service assistance, please call 888-830-1326 or
visit us at our WEB site at http://www.hunterfan.com.
Hunter Fan Company
2500 Frisco Avenue
Memphis, Tennessee 38114
41810-01_rev 8-20-04 v 3.pmd 8/21/04, 4:36 PM12