Filter
Top Products
© 2004 Hunter Fan Company 41810-01 08/20/2004
11
installing the switch housing cap and plug button
Install the switch housing cap and plug button to the lower switch
housing as shown in Figure 33.
Figure 33 - Installing the switch
housing cap and plug button
installing the lower switch housing
1. First insert the plug from the upper housing into the plug re-
ceptacle in the receiver module.
NOTE: The plug is polarized and will only go together one
way. Make sure you have correctly aligned plug and receptacle.
2. Place the lower switch housing assembly over the upper switch
housing. Align the side screw holes in the upper and lower
switch housings. Attach the lower switch housing to the up-
per switch housing with three #6-32 x 3/8" housing assembly
screws. See Figure 30.
NOTE: If the two pieces are difficult to assemble, check the
alignment of the (3) slots in the top of the receiver module
and the mounting holes in the lower switch housing. They
should align together.
operating your ceiling fan
1. Turn on electrical power to the fan.
2. Ceiling fans work best by blowing air downward (counterclock-
wise blade rotation) in warm weather to cool the room with a
direct breeze. In winter, having the fan draw air upward (clock-
wise blade rotation) will distribute the warmer air trapped at
the ceiling around the room without causing a draft. Refer to
Figure 34.
Figure 34 - Air flow patterns
operating the remote control
The hand-held transmitter has individual buttons for control of the
light, for controlling the fan speeds, for turning the fan off, and for
reversing. See Figure 35.
Pressing the “LIGHT” button will turn the light on to full bright-
ness. Holding the button will cause the light to dim slowly—re-
lease the button at the desired brightness to hold the selected
brightness level. Pushing the button again will turn the light off.
The fan may be started by pressing the HIGH, MEDIUM, or LOW
speed buttons. For best operation, allow the fan to start on HIGH,
then select the desired speed. Press the fan OFF button to turn the
ceiling fan off. Press the REVERSE button to change the fan’s direc-
tion while the fan is running.
NOTE: Replace 12-volt battery with type 23 A, MN-21 or equiva-
lent.
Figure 35 - Remote operation
mounting the remote holder
A holder is supplied with the transmitter which can be mounted to
a existing toggle switch wall plate. The holder will help prevent mis-
placement of your transmitter by providing a permanent recep-
tacle. See Figure 36.
If desired, the holder can be mounted to a convenient location on
a wall.
Figure 36 - Remote holder assembly
Lower Switch
Housing
Plug Button
Cap
Reverse
Fan High
Fan Medium
Fan Low
Fan Off
Light Key
41810-01_rev 8-20-04 v 3.pmd 8/21/04, 4:36 PM11