Filter
Top Products
41810-01 08/20/2004 © 2004 Hunter Fan Company
10
installing the glass bowl
Refer to Figure 31.
1. Install two max 60 Watt medium base incandescent bulbs.
2. Remove the cover plate and finial from the threaded rod on
the light fixture.
3. Place the cover plate up against the glass bowl. Align the holes
in the cover plate and glass bowl.
4. Screw the finial onto the threaded rod end until tight.
Figure 31 - Installing the glass bowl
installing without the light fixture
Your Hunter fan comes with an integrated light fixture assembly
and an optional switch housing cap and plug button. This feature
gives you the option of installing the fan with or without the in-
cluded light fixture.
If you decide to install the fan without the integrated light fixture
please complete the following instructions to install the optional
switch housing cap and plug button.
attaching the upper switch housing
1. Partially install two #6-32 x 3/8" housing assembly screws into
the switch housing mounting plate as shown in Figure 28.
2. Feed the upper plug connector through the center opening of
the upper switch housing. See Figure 28.
3. Align the keyhole slots in the upper switch housing with the
housing assembly screws installed previously.
4. Turn the upper switch housing counterclockwise until the
housing assembly screws are firmly situated in the narrow end
of the keyhole slots as shown in Figure 29. Install the one re-
maining #6-32 x 3/8" housing assembly screw into the third hole
in the upper switch housing. Tighten all three screws firmly.
CAUTION: Make sure the upper switch housing is se-
curely attached to the switch housing mounting plate. Fail-
ure to properly attach and tighten all three housing assem-
bly screws could result in the switch housing and light fix-
ture falling.
attaching the lower switch housing
uninstalling the light fixture
Refer to Figure 32.
1. Remove the receiver from the lower switch housing.
2. Disconnect the plug connectors between the black wire and
the black/white wire.
3. Disconnect the plug connectors between the two white wires.
4. Uninstall the nut and washer from the end of the light fixture
inside of the lower switch housing.
5. Unscrew the threaded rod of the light fixture from the lower
switch housing.
6. Remove the light fixture from the lower switch housing pull-
ing disconnected wires through the hole in the center of the
lower switch housing.
NOTE: When removing the wires, pull the thin plug connec-
tor (male) through first, and then pull the other plug connec-
tor (female) through the hole.
7. Install the dummy terminals (included in the sack parts) on
the two disconnected wires in the lower switch housing.
8. Replace the receiver, making sure the mounting holes at the
top of the switch housing line up with the matching slots in
the top of the receiver.
Figure 32 - Removing the light fixture
Lower Switch
Housing
Glass Bowl
Threaded Rod
Cover Plate
Finial
Metal Disk
Lower Switch
Housing
Threaded Rod
41810-01_rev 8-20-04 v 3.pmd 8/21/04, 4:36 PM10